Yongkang Yu Pei Coating Equipment Co., Ltd. ------ gun Precautions: If the gun immediately after use without cleaning spray machine wholesale radiators, partially or completely plugged nozzle will spray machine Which radiator strong, leading to the spray gun spray split (spray dried paint chips) or spray form is wrong. With additives for enamels, especially. Because if you do not wash immediately after use, enamel will harden inside the gun. Painting Equipment Co., Ltd. Yongkang Yu Pei ------ 1. spray powder coating process, at high pressure electrostatic field, the spray gun then negative, grounding of the workpiece (anode) form a loop radiator spray machine, powder by means of compressed air from the spray gun that is a negative charge, according to the principle that opposites attract sprayed onto the workpiece. 2. curing, spraying the workpiece after heating into 180 to 200 degrees Celsius, drying room, the powder is cured. 3. Clean, after coating is cured, remove the protective sheet was heated injection molding machine manufacturer, Shuhei glitches. 4. Verify, check the workpiece coating, where the tainted spray, bumps, bubbles and other defects needle should rework spray. 5. defect treatment, a leak was detected in the spray, pinholes, bumps, bubbles and other defects of the workpiece, re-sprayed after repair. Radiator spray machine wholesale | Yu Pei painting equipment (certified) | Guangxi radiator injection molding machine provided by Yongkang Yu Pei Coating Equipment Co. Yongkang Yu Pei Coating Equipment Co., Ltd. (www.ypsb.cn114114.com) is an industry leader in Jinhua, Zhejiang, industry-specific equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customers needs. Yu Pei leader in coating equipment with the staff warmly welcome all inquiries negotiations to create the painting equipment Yu Pei better future.